Dyson gets shit on frequently for being overpriced, but the audible analysis they do one some of their products is crazy complex. Some years ago I watched 30 minute video on the design they did for the hair dryer where they were designing minute angles in the fins of the air impeller, and using a PWM algorithm to measure backpressure in a feed back loop to spin up the fan where it wouldn’t create loud noise while also increasing the volume of air moved. They tuned the mechanisms specifically to shave off tiny peaks in oscilloscope readings.
One thing I remember is that they said they couldn’t entirely eliminate the specific annoying sound frequencies because it had to ramp, but what they did is ramp to right below the annoying sound frequency level, then hold, then burst above the annoying frequency band very quickly. So the operator of the unit doesn’t hear the annoying sound because the device shoots past it so fast.
I’ve never heard of any company be that picky and put so much effort into avoiding one negative experience of a product.
And then they go and make an idiotic bathroom hand air dryer that is vertical and unnatural to dip hands into and too small of an opening so as to be difficult to not touch it with your clean hands.
They also really really work well, theyre over engineered like crazy but last forever.
Maybe the old Dysons. The new ones are rubbish. Shark all the way.
what they did :
“Our product takes in a full blow of air and separates it,” said team member Leen Alfaoury. “Some of that air comes out as it is, and part of it comes out shifted. The combination of these two sections of the air makes the blower less noisy.”
Adds Chacon: “It ultimately dampens the sound as it leaves, but it keeps all that force, which is the beauty of it.”
Their design cuts the most shrill and annoying frequencies by about 12 decibels, which all but removes them, making them 94% quieter.
I wonder if that shares the same physics as silvent’s compressed air guns.
Silvent’s air nozzles reduce the sound level when blowing with compressed air compared to blowing through open pipes. This is due in part to the reduction in noisy turbulence from using Silvent’s air nozzles, and also because of the nozzles’ special design. Silvent’s air nozzles pass the compressed air through small holes and slots, which raises the sound to frequencies beyond what the human ear can perceive. This allows us to make blowing with compressed air both quiet and efficient.
Could use an even quieter compressed air gun
wtf is shifting?
The wording is comically awkward and imprecise. But if I had to guess, they figured out a way to fiddle with how the air is routed through the secondary portion such that the emitted noise is phase-shifted to cancel out the frequencies they’re targeting.
Seems baffling
But you can’t deny it has a certain flow to it
